PDA

View Full Version : TWM manifold for Carburetor setup



4agze
02-28-2009, 10:10 AM
Up for sale is a discontinued TWM manifold for a 4AGE engine. This is for running side draft carburetors. It bolts up to the head with no mods and uses two side draft carburetors such at webber 40s or similer.

Never been used or installed.
When new over $300
Selling for $250

Thanks
Matt

http://www.bcmr2.com/matt/4sale/sale9.JPG

http://www.bcmr2.com/matt/4sale/sale10.JPG

Jeff Lange
02-28-2009, 11:03 AM
What's the diameter on the inlets?

Jeff

SalEsh
02-28-2009, 12:44 PM
pm'D!!!


Brandon

rywats
02-28-2009, 12:57 PM
I don't think that one will work with your FCR..

4agze
02-28-2009, 01:39 PM
Will measure and post after I get off work. It was made for a large port 4AGE head. But will measure for sure and post.

PMed back SalEsh.

tosh
02-28-2009, 05:11 PM
this can also be used for an itbs setup with some mods and an adapter plate. nice peice, wish i had some cash.

peace

4agze
02-28-2009, 05:52 PM
Hey guys so here it is
Inlet opening = 1 inch and 13/16 (a hair bigger than 1.75)

Sale Pending!

SalEsh
02-28-2009, 11:01 PM
sold pm'd!!!!


Brandon

4agze
03-01-2009, 04:54 PM
SOLD!
thank you

SalEsh
03-01-2009, 08:06 PM
:D:D:D

thank you!!

Brandon

hkeum2001
03-01-2009, 09:51 PM
:worship::worship: