Results 1 to 4 of 4

Thread: Beams ae86 functioning stock tach

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Sep 2010
    Location
    Nanaimo, B.C.
    Posts
    1,758

    Beams ae86 functioning stock tach

    It took me to long to find this info so id like to share it here for future people

    So AE86 with a beams swapped in it, running factory ECU.

    the tach output is D26 from the ecu
    http://www.sq-engineering.com/downlo...ng_Diagram.pdf

    splice this wire into the tach signal that would have some from the ignition coil i choose to use pin 13 for ease.
    Click image for larger version. 

Name:	86wire.jpg 
Views:	75 
Size:	56.7 KB 
ID:	15772

    now the fun part, remove your dash cluster, and remove the plastic cover. remove the screws from behind the tach side, not all need to be removed the tach and speedo are 2 individual units tho they appear to be one.
    once removed you need to add a 10 ohm 1/4 watt resistor (people confirm that 100 hm works also) to the R4 circuit. there is no need to remove the old resistor as power will take the path of least resistance. To save hassle i soldered it on the other side rather then trying to make a clean cut to remove the stock one. once you've done this your board should like this
    Click image for larger version. 

Name:	IMG_0059.jpg 
Views:	77 
Size:	22.3 KB 
ID:	15773

    now your set plug it in rev it up and watch your tach bounce off rev limiter.

    it cost me 1.20$ for 10 resistors if anyone needs one let me know.
    it took roughly 45 minutes to wire the circuit and install the resistor

    cheaper and faster then both the msd box and the relay guys use to make it work
    Last edited by oldskoolcool; 08-15-2018 at 10:16 PM.
    OldSkoolCustoms

    More old toyotas then common sense

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •